Frosted Beer Can Glass 13oz

This 13oz Frosted Glass Can is perfect for any kitchen or patio. Personalize it with sublilmation or heat transfer

Shrink wrap sizes 150-4 9.8" x 5.9"  or 125-1 9.8" x 4.9"

Printing Instructions

Recommended Settings- Constant Temperatur Mug Press

Time 90-120 seconds

Temperature 370-380°F

Pressure Light/Medium

General Sublimation Instructions - Constant Temperature Mug Press • Preheat the press to 370-380°F. Set the time to 90-120 sec., set pressure to light/medium. • Wipe down the glass with soft cloth misted with isopropyl alcohol. • Print and apply transfer to the product using heat tape to secure the transfer to the glass. • Place the glass into the mug press. Close and press for recommended time. • When finished, while wearing heat gloves remove the glass from press and carefully remove the transfer paper from the glass. Discard the transfer paper, set aside to cool.

General Sublimation Instructions - Variable Temperature Mug Press

• Preheat the press to 220° F idle temp., and 350-360° F press temperature. Set the time to 10-20 sec., set pressure to light/medium.

• Wipe down the glass with soft cloth misted with isopropyl alcohol.

• Print and apply transfer to the product using heat tape to secure the transfer to the glass.

• Place the glass into the mug press. Close and press for recommended time.

• When finished, while wearing heat gloves remove the glass from press and carefully remove the transfer paper from the glass. Discard the transfer paper.

o CAUTION: Be very careful not to scratch or damage the frosted coating on the glass, as the coating is very fragile while the glass is still hot.

• Set glass aside to cool

Recommended Settings- Convection Oven

Time 9-12 minutes

Temperature 380-400°F

Pressure Light/Medium

General Sublimation Instructions - Convection Oven

• Preheat oven to 380-400°F while preparing the glass.

• Print and place the transfer face down on the glass. Secure transfer with heat tape.

• If using Shrink Sleeves, slide heat shrink sleeve over top of the transfer paper. Use the heat gun to shrink the sleeve onto the glass. o For best results, shrink one end of the sleeve first to help secure the transfer position on the glass.

o If applicable, shrinking the opposite side from the transfer paper first gives best results.

• If using the Quick Release Wrap, wrap the product and close by clasping metal ends. o Be careful not to overtighten the glass if the Quick Release Wrap needs to be adjusted.

• Once oven is preheated, place glass in oven. Close and heat for the recommended time.

• When finished, while wearing heat gloves remove the glass from oven and carefully remove the Shrink Sleeve or Quick Release Wrap from the glass.

• Remove the transfer paper from the glass. Discard the transfer paper.

o CAUTION: Be very careful not to scratch or damage the frosted coating on the glass, as the coating is very fragile while the glass is still hot.

• Set glass aside to cool.

o IMPORTANT: Do not submerge glass in water to help cool, as this may crack or break the glass

• MultiTrans CMYK (W)
• MultiTrans Metallics (Gold and Silver)

QDS Laser Ceramic Paper